Commit 3e057e48 authored by Chen-Yu Tsai's avatar Chen-Yu Tsai Committed by Hans de Goede

sunxi: Enable SPL support for A80 Optimus board

The A80 Optimus Board was launched with the Allwinner A80 SoC.
It was jointly developed by Allwinner and Merrii.

This board has a UART port, a JTAG connector, 2 USB host ports, a USB
3.0 OTG connector, an HDMI output, a micro SD slot, 16G eMMC flash,
2G DRAM, a camera sensor interface, a WiFi/BT combo chip, a headphone
jack, IR receiver, and additional GPIO headers.
Signed-off-by: default avatarChen-Yu Tsai <wens@csie.org>
[hdegoede@redhat.com: update existing Merrii_A80_Optimus_defconfig
 instead of adding a new defconfig]
Acked-by: default avatarHans de Goede <hdegoede@redhat.com>
Signed-off-by: default avatarHans de Goede <hdegoede@redhat.com>
parent 58b628ed
...@@ -94,6 +94,11 @@ M: Stefan Mavrodiev <stefan.mavrodiev@gmail.com> ...@@ -94,6 +94,11 @@ M: Stefan Mavrodiev <stefan.mavrodiev@gmail.com>
S: Maintained S: Maintained
F: configs/A33-OLinuXino_defconfig F: configs/A33-OLinuXino_defconfig
A80 OPTIMUS BOARD
M: Chen-Yu Tsai <wens@csie.org>
S: Maintained
F: configs/Merrii_A80_Optimus_defconfig
AINOL AW1 BOARD AINOL AW1 BOARD
M: Paul Kocialkowski <contact@paulk.fr> M: Paul Kocialkowski <contact@paulk.fr>
S: Maintained S: Maintained
......
CONFIG_ARM=y CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y CONFIG_ARCH_SUNXI=y
CONFIG_MACH_SUN9I=y CONFIG_MACH_SUN9I=y
CONFIG_DRAM_CLK=360 CONFIG_DRAM_CLK=672
CONFIG_DRAM_ZQ=123
CONFIG_SYS_CLK_FREQ=1008000000
CONFIG_MMC0_CD_PIN="PH18" CONFIG_MMC0_CD_PIN="PH18"
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_USB0_ID_DET="PH3"
CONFIG_USB1_VBUS_PIN="PH4"
CONFIG_USB3_VBUS_PIN="PH5"
CONFIG_AXP_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="sun9i-a80-optimus" CONFIG_DEFAULT_DEVICE_TREE="sun9i-a80-optimus"
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set CONFIG_SPL=y
CONFIG_CONSOLE_MUX=y
# CONFIG_CMD_IMLS is not set # CONFIG_CMD_IMLS is not set
# CONFIG_CMD_FLASH is not set # CONFIG_CMD_FLASH is not set
# CONFIG_CMD_FPGA is not set # CONFIG_CMD_FPGA is not set
CONFIG_AXP809_POWER=y
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment