1. 29 Jun, 2018 2 commits
    • Eric Kuzmenko's avatar
      Make the ETH PHY's crystal's load capacitors 27pF instead of 22pF, Cstray... · 10d742e3
      Eric Kuzmenko authored
      Make the ETH PHY's crystal's load capacitors 27pF instead of 22pF, Cstray should now be 3.5pF instead of 7pF
      10d742e3
    • Eric Kuzmenko's avatar
      Move USB-C, Mini-HDMI, RJ45, and 3.5mm jack receptacles to the bottom of the... · 71d87ac3
      Eric Kuzmenko authored
      Move USB-C, Mini-HDMI, RJ45, and 3.5mm jack receptacles to the bottom of the board, also place the Micro-SD card slot to the left of all of the receptacles centered at the bottom, place the Smart-Card slot just above the Micro-SD card facing the left, add 3D models to each of the respective connectors/sockets
      
      The order of the various receptacles and sockets can be changed bit the pitch between them should stay about the same since it is currently as tightly packed asreasonably possible (1.5~2.5mm clearance between connectors).
      71d87ac3
  2. 28 Jun, 2018 5 commits
  3. 27 Jun, 2018 2 commits
  4. 26 Jun, 2018 1 commit
  5. 25 Jun, 2018 3 commits
  6. 24 Jun, 2018 2 commits
  7. 23 Jun, 2018 1 commit
  8. 22 Jun, 2018 4 commits
  9. 21 Jun, 2018 2 commits
  10. 19 Jun, 2018 3 commits
  11. 17 Jun, 2018 1 commit
  12. 15 Jun, 2018 7 commits
  13. 14 Jun, 2018 2 commits
  14. 13 Jun, 2018 4 commits
  15. 12 Jun, 2018 1 commit
    • Eric Kuzmenko's avatar
      Add GNSS antenna footprint including correct 50Ohm feed line dimensions and... · 05b25768
      Eric Kuzmenko authored
      Add GNSS antenna footprint including correct 50Ohm feed line dimensions and keepout area, add u-blox MAX-8 3D model, rename all instances of MAX-M8* to MAX-8* due to part selection, antenna feed line calculatos included (coplanar waveguide)
      
      Need to add placeholder footprints for the other four antennae which will be represented as simple rectangular areas where the antennae will occupy. After that, all that is left is to assign the various remaining IC footprints and finally import all footprints into PCBNew & begin layout!
      05b25768