1. 28 Jul, 2018 1 commit
    • Eric Kuzmenko's avatar
      Begin routing the HDMI circuit · 8c2544ff
      Eric Kuzmenko authored
      Needed to create the HDMI_HEAC_P/N labels to route Utility&HPD as diff pairs. Made cap C1905 NC, which is in parallel with a 0Ohm resistor between the HDMI sheilding and GND.
      8c2544ff
  2. 27 Jul, 2018 1 commit
  3. 26 Jul, 2018 1 commit
  4. 24 Jul, 2018 1 commit
  5. 20 Jul, 2018 1 commit
  6. 19 Jul, 2018 2 commits
  7. 17 Jul, 2018 1 commit
  8. 16 Jul, 2018 2 commits
  9. 14 Jul, 2018 1 commit
  10. 09 Jul, 2018 2 commits
  11. 05 Jul, 2018 2 commits
  12. 04 Jul, 2018 1 commit
    • Eric Kuzmenko's avatar
      Now using GPIO5_IO03 (P4.03) to put the class-D op-amp in shutdown and... · 3bf0094e
      Eric Kuzmenko authored
      Now using GPIO5_IO03 (P4.03) to put the class-D op-amp in shutdown and conserve energy when muted, make C1716 near the ETH PHY's DVDDL pin 47 220nF instead of 10uF (EmCraft suggested that this should be 100nF but their's is 220nF, asked why), added a 10k pull-down to PAM2841's ENA pin, added a 100nF cap to the smart card's C1 VCC pin, added a 1uF cap to the haptic motor circuit's 3V3_P rail
      
      Still need to use I2C3 instead of I2C1 according to EmCraft's suggestions.
      3bf0094e
  13. 03 Jul, 2018 3 commits
  14. 02 Jul, 2018 1 commit
  15. 30 Jun, 2018 1 commit
  16. 29 Jun, 2018 3 commits
  17. 28 Jun, 2018 5 commits
  18. 27 Jun, 2018 2 commits
  19. 26 Jun, 2018 1 commit
  20. 25 Jun, 2018 3 commits
  21. 24 Jun, 2018 2 commits
  22. 23 Jun, 2018 1 commit
  23. 22 Jun, 2018 2 commits