1. 21 Aug, 2018 7 commits
  2. 20 Aug, 2018 5 commits
  3. 19 Aug, 2018 6 commits
  4. 18 Aug, 2018 4 commits
  5. 17 Aug, 2018 1 commit
    • Eric Kuzmenko's avatar
      Update the fabrication drawing file with more information · 7d4a9d76
      Eric Kuzmenko authored
      This file was created by exporting both the Cmts.User layer, as well as the NPTH&PTH drills into separate DXF files, then combining them in the footprint editor, finally, this new footprint made from both of these is imported into the layout and re-exported as a single DXF.
      7d4a9d76
  6. 16 Aug, 2018 9 commits
  7. 15 Aug, 2018 6 commits
  8. 14 Aug, 2018 2 commits
    • Eric Kuzmenko's avatar
      Make the ENET_* traces on the top layer 53mils in order to ensure they have a... · 2456bfb3
      Eric Kuzmenko authored
      Make the ENET_* traces on the top layer 53mils in order to ensure they have a 50Ohm single-ended impedence, move one of the 5V_P bypass caps close to the SoM end of the USB2 diff pair, add meanders to the ENET_TXC, ENET_TX_CTL, ENET_RX_CTL in order to ensure these segments are matched to the long ENET_RXC segment (56.051mm, the rest of the RGMII signals are <10mm skew from this length and don't need adjusting, re-route the SIM card such that UIM-RESET is routed in between UIM-CLK and UIM-DATA as recommended by a BB manufacturer
      2456bfb3
    • Christian Schilmoeller's avatar
      Rework length adjustment of SD card (one signal was too long). · 294b77fb
      Christian Schilmoeller authored
      Changed width of RGMII traces to 0.127 mm.
      Removed unnecessary tiny segments/stubs.
      294b77fb