opp: core: silence noisy opp debug message

This message prints out on every dvfs transtion and fills the kernel
log. Remove it.
Signed-off-by: 's avatarAngus Ainslie (Purism) <angus@akkea.ca>
parent 5d0fdb2f
Pipeline #5152 passed with stage
in 29 minutes and 52 seconds
......@@ -538,8 +538,10 @@ static int _set_opp_voltage(struct device *dev, struct regulator *reg,
return 0;
}
#if 0
dev_dbg(dev, "%s: voltages (mV): %lu %lu %lu\n", __func__,
supply->u_volt_min, supply->u_volt, supply->u_volt_max);
#endif
ret = regulator_set_voltage_triplet(reg, supply->u_volt_min,
supply->u_volt, supply->u_volt_max);
......@@ -756,8 +758,10 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
goto put_old_opp;
}
#if 0
dev_dbg(dev, "%s: switching OPP: %lu Hz --> %lu Hz\n", __func__,
old_freq, freq);
#endif
/* Scaling up? Configure required OPPs before frequency */
if (freq >= old_freq) {
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment