README.ocotea 1.83 KB
Newer Older
Wolfgang Denk's avatar
Wolfgang Denk committed
1
			   AMCC Ocotea Board
wdenk's avatar
wdenk committed
2 3 4 5

		    Last Update: March 2, 2004
=======================================================================

Wolfgang Denk's avatar
Wolfgang Denk committed
6
This file contains some handy info regarding U-Boot and the AMCC
7
Ocotea 440gx  evaluation board. See the README.ppc440 for additional
wdenk's avatar
wdenk committed
8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55
information.


SWITCH SETTINGS & JUMPERS
==========================

Here's what I've been using successfully. If you feel inclined to
change things ... please read the docs!

DIPSW   U46         U80
------------------------
SW 1    off         off
SW 2    on          off
SW 3    off         off
SW 4    off         off
SW 5    off         off
SW 6    on          on
SW 7    on          off
SW 8    on          off

J41: strapped
J42: open

All others are factory default.


I2C Information
=====================

See README.ebony for information.

PCI
===========================

Untested at the time of writing.

PPC440GX Ethernet EMACs
===========================

All EMAC ports have been tested and are known to work
with EPS Group 4.

Special note about the Cicada CIS8201:
	The CIS8201 Gigabit PHY comes up in GMII mode by default.
	One must hit an extended register to allow use of RGMII mode.
	This has been done in the 440gx_enet.c file with a #ifdef/endif
	pair.

Wolfgang Denk's avatar
Wolfgang Denk committed
56
AMCC does not store the EMAC ethernet addresses within their PIBS bootloader.
wdenk's avatar
wdenk committed
57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73
The addresses contained in the config header file are from my particular
board and you _*should*_ change them to reflect your board either in the
config file and/or in your environment variables.  I found the addresses on
labels on the bottom side of the board.


BDI2k or JTAG Debugging
===========================

For ease of debugging you can swap the small boot flash and external SRAM
by changing U46:3 to on.  You can then use the sram as your boot flash by
loading the sram via the jtag debugger.


Regards,
--Travis
<tsawyer@sandburst.com>