• Codrin Ciubotariu's avatar
    drivers: net: vsc9953: Add LAG support · aae0e689
    Codrin Ciubotariu authored
    You can now configure LAG on VSC9953's ports using the command:
    ethsw [port <port_no>] aggr {[help] | show | <lag_group_no>}
    A port must belong to a single LAG. By default, a port
    belongs to a LAG equal to the port's number.
    For each frame, a hash will be calculated based on
    Source/Destination MAC addresses, Source/Destination IP(v4/v6)
    addresses, Source/Destination ports. This hash will be used to
    select a single egress port from LAG. This also assures
    that frames from the same flow will always have the
    same egress port.
    Signed-off-by: default avatarCodrin Ciubotariu <codrin.ciubotariu@freescale.com>
    Acked-by: default avatarJoe Hershberger <joe.hershberger@ni.com>
README.t1040-l2switch 2.92 KB