Commit 1f516faa authored by Peng Fan's avatar Peng Fan Committed by Stefano Babic
Browse files

ARM: imx6: disable bandgap self-bias after boot



The self-bias circuit is used by the bandgap during startup.
Once the bandgap has stabilized, the self-bias circuit should
be disabled for best noise performance of analog blocks.
Also this bit should be disabled before the chip enters STOP mode or
when ever the regular bandgap is disabled.
Signed-off-by: default avatarPeng Fan <Peng.Fan@freescale.com>
Signed-off-by: default avatarRanjani Vaidyanathan <Ranjani.Vaidyanathan@freescale.com>
parent e72d3443
......@@ -255,6 +255,23 @@ static void clear_mmdc_ch_mask(void)
writel(0, &mxc_ccm->ccdr);
}
static void init_bandgap(void)
{
struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
/*
* Ensure the bandgap has stabilized.
*/
while (!(readl(&anatop->ana_misc0) & 0x80))
;
/*
* For best noise performance of the analog blocks using the
* outputs of the bandgap, the reftop_selfbiasoff bit should
* be set.
*/
writel(BM_ANADIG_ANA_MISC0_REFTOP_SELBIASOFF, &anatop->ana_misc0_set);
}
#ifdef CONFIG_MX6SL
static void set_preclk_from_osc(void)
{
......@@ -274,6 +291,13 @@ int arch_cpu_init(void)
/* Need to clear MMDC_CHx_MASK to make warm reset work. */
clear_mmdc_ch_mask();
/*
* Disable self-bias circuit in the analog bandap.
* The self-bias circuit is used by the bandgap during startup.
* This bit should be set after the bandgap has initialized.
*/
init_bandgap();
/*
* When low freq boot is enabled, ROM will not set AHB
* freq, so we need to ensure AHB freq is 132MHz in such
......
......@@ -1063,4 +1063,6 @@ struct mxc_ccm_reg {
#define BF_ANADIG_PFD_528_PFD0_FRAC(v) \
(((v) << 0) & BM_ANADIG_PFD_528_PFD0_FRAC)
#define BM_ANADIG_ANA_MISC0_REFTOP_SELBIASOFF 0x00000008
#endif /*__ARCH_ARM_MACH_MX6_CCM_REGS_H__ */
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment