Commit 2e26d837 authored by Jason Jin's avatar Jason Jin Committed by Wolfgang Denk
Browse files

Enabled the Freescale SGMII riser card on 8536DS


Signed-off-by: default avatarJason Jin <Jason.jin@freescale.com>
parent 7e183cad
......@@ -35,8 +35,11 @@
#include <libfdt.h>
#include <spd_sdram.h>
#include <fdt_support.h>
#include <tsec.h>
#include <netdev.h>
#include "../common/pixis.h"
#include "../common/sgmii_riser.h"
#if defined(CONFIG_DDR_ECC) && !defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
extern void ddr_enable_ecc(unsigned int dram_size);
......@@ -618,6 +621,45 @@ int is_sata_supported(void)
return 1;
}
int board_eth_init(bd_t *bis)
{
#ifdef CONFIG_TSEC_ENET
struct tsec_info_struct tsec_info[2];
volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
int num = 0;
uint sdrs2_io_sel =
(gur->pordevsr & MPC85xx_PORDEVSR_SRDS2_IO_SEL) >> 27;
#ifdef CONFIG_TSEC1
SET_STD_TSEC_INFO(tsec_info[num], 1);
if ((sdrs2_io_sel == 4) || (sdrs2_io_sel == 6)) {
tsec_info[num].phyaddr = 0;
tsec_info[num].flags |= TSEC_SGMII;
}
num++;
#endif
#ifdef CONFIG_TSEC3
SET_STD_TSEC_INFO(tsec_info[num], 3);
if (sdrs2_io_sel == 4) {
tsec_info[num].phyaddr = 1;
tsec_info[num].flags |= TSEC_SGMII;
}
num++;
#endif
if (!num) {
printf("No TSECs initialized\n");
return 0;
}
if ((sdrs2_io_sel == 4) || (sdrs2_io_sel == 6))
fsl_sgmii_riser_init(tsec_info, num);
tsec_eth_init(bis, tsec_info, num);
#endif
return pci_eth_init(bis);
}
#if defined(CONFIG_OF_BOARD_SETUP)
void
ft_board_setup(void *blob, bd_t *bd)
......
......@@ -427,6 +427,9 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
#define CONFIG_TSEC3 1
#define CONFIG_TSEC3_NAME "eTSEC3"
#define CONFIG_FSL_SGMII_RISER 1
#define SGMII_RISER_PHY_OFFSET 0x1c
#define TSEC1_PHY_ADDR 1 /* TSEC1 -> PHY1 */
#define TSEC3_PHY_ADDR 0 /* TSEC3 -> PHY0 */
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment