Commit 6d38f3a8 authored by Tim Harvey's avatar Tim Harvey Committed by Stefano Babic
Browse files

imx: ventana: detect pmic using i2c probe instead of board model



Avoid requiring board-model and probe pmic by its i2c address.
This is in preparation for being able to call pmic_setup() from SPL
and not need board type.
Signed-off-by: default avatarTim Harvey <tharvey@gateworks.com>
parent 2d833c85
......@@ -759,13 +759,16 @@ void setup_board_gpio(int board, struct ventana_board_info *info)
}
/* setup board specific PMIC */
void setup_pmic(int board)
void setup_pmic(void)
{
struct pmic *p;
u32 reg;
i2c_set_bus_num(CONFIG_I2C_PMIC);
/* configure PFUZE100 PMIC */
if (board == GW54xx || board == GW54proto) {
if (!i2c_probe(CONFIG_POWER_PFUZE100_I2C_ADDR)) {
debug("probed PFUZE100@0x%x\n", CONFIG_POWER_PFUZE100_I2C_ADDR);
power_pfuze100_init(CONFIG_I2C_PMIC);
p = pmic_get("PFUZE100");
if (p && !pmic_probe(p)) {
......@@ -787,7 +790,8 @@ void setup_pmic(int board)
}
/* configure LTC3676 PMIC */
else {
else if (!i2c_probe(CONFIG_POWER_LTC3676_I2C_ADDR)) {
debug("probed LTC3676@0x%x\n", CONFIG_POWER_LTC3676_I2C_ADDR);
power_ltc3676_init(CONFIG_I2C_PMIC);
p = pmic_get("LTC3676_PMIC");
if (p && !pmic_probe(p)) {
......
......@@ -89,7 +89,7 @@ void setup_ventana_i2c(void);
/* configure uart iomux */
void setup_iomux_uart(void);
/* conifgure PMIC */
void setup_pmic(int board);
void setup_pmic(void);
/* configure gpio iomux/defaults */
void setup_iomux_gpio(int board, struct ventana_board_info *);
/* late setup of GPIO (configuration per baseboard and env) */
......
......@@ -468,7 +468,7 @@ static void setup_display(void)
/* setup board specific PMIC */
int power_init_board(void)
{
setup_pmic(board_type);
setup_pmic();
return 0;
}
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment