Commit 961954ea authored by Mike Frysinger's avatar Mike Frysinger
Browse files

Blackfin: use 8/16/32 bit transfer widths in dma_memcpy()



Rather than using 8bit transfers for everything, use 8/16/32 bit transfers
as usable with the source/destination addresses and the count size.
Signed-off-by: default avatarMike Frysinger <vapier@gentoo.org>
parent b93c6864
......@@ -136,6 +136,8 @@ int strncmp(const char *cs, const char *ct, size_t count)
*/
void dma_memcpy_nocache(void *dst, const void *src, size_t count)
{
uint16_t wdsize, mod;
/* Disable DMA in case it's still running (older u-boot's did not
* always turn them off). Do it before the if statement below so
* we can be cheap and not do a SSYNC() due to the forced abort.
......@@ -151,24 +153,37 @@ void dma_memcpy_nocache(void *dst, const void *src, size_t count)
(unsigned long)dst < L1_SRAM_SCRATCH_END))
hang();
if (((unsigned long)dst | (unsigned long)src | count) & 0x1) {
wdsize = WDSIZE_8;
mod = 1;
} else if (((unsigned long)dst | (unsigned long)src | count) & 0x2) {
wdsize = WDSIZE_16;
count >>= 1;
mod = 2;
} else {
wdsize = WDSIZE_32;
count >>= 2;
mod = 4;
}
/* Copy sram functions from sdram to sram */
/* Setup destination start address */
bfin_write_MDMA_D0_START_ADDR(dst);
/* Setup destination xcount */
bfin_write_MDMA_D0_X_COUNT(count);
/* Setup destination xmodify */
bfin_write_MDMA_D0_X_MODIFY(1);
bfin_write_MDMA_D0_X_MODIFY(mod);
/* Setup Source start address */
bfin_write_MDMA_S0_START_ADDR(src);
/* Setup Source xcount */
bfin_write_MDMA_S0_X_COUNT(count);
/* Setup Source xmodify */
bfin_write_MDMA_S0_X_MODIFY(1);
bfin_write_MDMA_S0_X_MODIFY(mod);
/* Enable source DMA */
bfin_write_MDMA_S0_CONFIG(DMAEN);
bfin_write_MDMA_D0_CONFIG(WNR | DMAEN | DI_EN);
bfin_write_MDMA_S0_CONFIG(wdsize | DMAEN);
bfin_write_MDMA_D0_CONFIG(wdsize | DMAEN | WNR | DI_EN);
SSYNC();
while (!(bfin_read_MDMA_D0_IRQ_STATUS() & DMA_DONE))
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment