Commit b24f7f00 authored by Hans de Goede's avatar Hans de Goede
Browse files

sunxi: Enable usb ports on the Sinovoip BPI M3



DLDO3 is used to provide Port-D power and PD is used for the
usb-hub / sata-5v enable pins. The 2.5V comes from the schematic
and matches the factory image fex file.

The dts changes are the minimal changes needed for u-boot to
pick-up the usb host controllers. The upstream kernel does not
(yet) have usb host support.
Signed-off-by: default avatarHans de Goede <hdegoede@redhat.com>
Acked-by: default avatarIan Campbell <ijc@hellion.org.uk>
parent e6c9cec4
......@@ -57,8 +57,16 @@
};
};
&ehci0 {
status = "okay";
};
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_pins_b>;
status = "okay";
};
&usb_otg {
status = "okay";
};
......@@ -5,6 +5,11 @@ CONFIG_DRAM_TYPE=7
CONFIG_DRAM_CLK=480
CONFIG_DRAM_ZQ=15355
CONFIG_DRAM_ODT_EN=y
CONFIG_INITIAL_USB_SCAN_DELAY=500
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_USB0_ID_DET="PH11"
CONFIG_USB1_VBUS_PIN="PD24"
CONFIG_AXP_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-sinovoip-bpi-m3"
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
......@@ -13,3 +18,7 @@ CONFIG_SPL=y
# CONFIG_CMD_FLASH is not set
# CONFIG_CMD_FPGA is not set
CONFIG_AXP_DCDC5_VOLT=1200
CONFIG_AXP_DLDO3_VOLT=2500
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_MUSB_HOST=y
CONFIG_SYS_EXTRA_OPTIONS="SATAPWR=SUNXI_GPD(25)"
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment