Commit d6815435 authored by wdenk's avatar wdenk
Browse files

Add default switch settings.

parent e6009629
......@@ -11,6 +11,20 @@ Installation Instructions:
| X|
------
Put the s3 switch into the following position:
1 0
------
|x |
|x |
|x |
|x |
|x |
| x|
| x|
|x |
------
2. Connect to the serial console and to the BDI. Power on. On the
serial line, you should see:
......@@ -34,8 +48,17 @@ Installation Instructions:
prog 0xB0000000 <u-boot.bin> bin
6. Power off. Restore the original S2 switch position. Power on.
U-Boot should come up.
6. Power off. Restore the original S2 switch position:
1 0
------
| x|
| x|
|x |
| X|
------
Power on. U-Boot should come up.
......@@ -48,5 +71,5 @@ can't really check whether 'erase' is complete by polling flash as it
is usually done. Instead, the flash driver simply waits for a given
time and assumes that erase then has passed. This behaviour is
identical to what the VxWorks driver does; also, the same timeout (6
seconds) was chosen. Note that this timeout applies for each errase
seconds) was chosen. Note that this timeout applies for each erase
operation, i. e. per erased sector.
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment