Commit e0c4fac7 authored by Andy Fleming's avatar Andy Fleming
Browse files

TQM85xx: Fix a couple warnings in TQM8548 build



The ecm variable in sdram.c was being declared for all 8548, but only
used by specific 8548 boards, so we make that variable require those
specific boards, too

The nand code was using an index "i" into a table, and then re-using "i"
to set addresses for each upm.  However, then it relied on the old value
of i still being there to enable things.  Changed the second "i" to "j"
Signed-off-by: default avatarAndy Fleming <afleming@freescale.com>
parent cf07a5ba
......@@ -395,7 +395,7 @@ static void upmb_write (u_char addr, ulong val)
*/
static void nand_upm_setup (volatile ccsr_lbc_t *lbc)
{
uint i;
uint i, j;
uint or3 = CONFIG_SYS_OR3_PRELIM;
uint clock = get_lbc_clock ();
......@@ -429,8 +429,8 @@ static void nand_upm_setup (volatile ccsr_lbc_t *lbc)
/* Assign address of table */
nand_upm_patt = upm_freq_table[i].upm_patt;
for (i = 0; i < 64; i++) {
upmb_write (i, *nand_upm_patt);
for (j = 0; j < 64; j++) {
upmb_write (j, *nand_upm_patt);
nand_upm_patt++;
}
......
......@@ -79,7 +79,9 @@ long int sdram_setup (int casl)
volatile ccsr_ddr_t *ddr = (void *)(CONFIG_SYS_MPC85xx_DDR_ADDR);
#ifdef CONFIG_TQM8548
volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
#if defined(CONFIG_TQM8548_AG) || defined(CONFIG_TQM8548_BE)
volatile ccsr_local_ecm_t *ecm = (void *)(CONFIG_SYS_MPC85xx_ECM_ADDR);
#endif
#else /* !CONFIG_TQM8548 */
unsigned long cfg_ddr_timing1;
unsigned long cfg_ddr_mode;
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment