Commit ef8e3a3b authored by Troy Kisky's avatar Troy Kisky Committed by Stefano Babic

net: fec_mxc: use fec_set_dev_name to set name

This allows us to create the phydev before calling
fec_probe in later patch.
Signed-off-by: default avatarTroy Kisky <troy.kisky@boundarydevices.com>
parent 1adb406b
......@@ -915,6 +915,11 @@ static int fec_recv(struct eth_device *dev)
return len;
}
static void fec_set_dev_name(char *dest, int dev_id)
{
sprintf(dest, (dev_id == -1) ? "FEC" : "FEC%i", dev_id);
}
static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr)
{
struct eth_device *edev;
......@@ -967,13 +972,8 @@ static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr)
fec_reg_setup(fec);
if (dev_id == -1) {
sprintf(edev->name, "FEC");
fec->dev_id = 0;
} else {
sprintf(edev->name, "FEC%i", dev_id);
fec->dev_id = dev_id;
}
fec_set_dev_name(edev->name, dev_id);
fec->dev_id = (dev_id == -1) ? 0 : dev_id;
fec->phy_id = phy_id;
bus = mdio_alloc();
......@@ -984,7 +984,7 @@ static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr)
}
bus->read = fec_phy_read;
bus->write = fec_phy_write;
sprintf(bus->name, edev->name);
fec_set_dev_name(bus->name, dev_id);
#ifdef CONFIG_MX28
/*
* The i.MX28 has two ethernet interfaces, but they are not equal.
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment