Commit fc6e3c81 authored by Tom Rini's avatar Tom Rini
Browse files

pico-imx6ul: Update the defconfig



The defconfig/config.h file were merged but were already out of sync
with mainline.  This brings them further into line now.

Cc: Richard Hu <richard.hu@technexion.com>
Cc: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: default avatarTom Rini <trini@konsulko.com>
parent a212d696
CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/technexion/pico-imx6ul/imximage.cfg"
CONFIG_TARGET_PICO_IMX6UL=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/technexion/pico-imx6ul/imximage.cfg"
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_IMLS is not set
CONFIG_CMD_MEMTEST=y
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_MMC=y
CONFIG_CMD_USB=y
CONFIG_CMD_USB_MASS_STORAGE=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_OF_LIBFDT=y
......@@ -31,14 +31,11 @@
#define CONFIG_SYS_FSL_ESDHC_ADDR USDHC1_BASE_ADDR
#define CONFIG_MMC
#define CONFIG_CMD_MMC
#define CONFIG_GENERIC_MMC
#define CONFIG_CMD_FAT
#define CONFIG_DOS_PARTITION
#define CONFIG_SUPPORT_EMMC_BOOT
/* USB Configs */
#define CONFIG_CMD_USB
#define CONFIG_USB_EHCI
#define CONFIG_USB_EHCI_MX6
#define CONFIG_USB_STORAGE
......@@ -52,7 +49,6 @@
#define CONFIG_USB_GADGET_DUALSPEED
#define CONFIG_USB_GADGET
#define CONFIG_CMD_USB_MASS_STORAGE
#define CONFIG_USB_FUNCTION_MASS_STORAGE
#define CONFIG_USB_GADGET_DOWNLOAD
#define CONFIG_USB_GADGET_VBUS_DRAW 2
......@@ -100,7 +96,6 @@
"fi; " \
"else run netboot; fi"
#define CONFIG_CMD_MEMTEST
#define CONFIG_SYS_MEMTEST_START 0x80000000
#define CONFIG_SYS_MEMTEST_END CONFIG_SYS_MEMTEST_START + SZ_128M
......@@ -134,7 +129,4 @@
#define CONFIG_SYS_MMC_ENV_PART 0
#define CONFIG_MMCROOT "/dev/mmcblk0p2"
#define CONFIG_CMD_BOOTZ
#define CONFIG_CMD_CACHE
#endif /* __PICO_IMX6UL_CONFIG_H */
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment