Signed-off-by: Stefan Roese <sr@denx.de>

currently sectors 0-3. Sector 3 does not need to be protected, though
(U-boot occupies sectors 0-1 and the environment sector 2). This commit
fixes this, i.e., only sectors 0-2 are protected.

"mii device" results in "Unexpected exception"). Fixing this properly
requires some clean-up in the FEC drivers infrastructure for ColdFire, so
this commit disables MII commads for now.

Identification Register (CIR).

Signed-off-by: Heiko Schocher <hs@denx.de>

             if you must swap the bytes between reading/writing.
             (Needed for the SC3 board)
Signed-off-by: Heiko Schocher <hs@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

             The EBC Configuration Register is now by CFG_EBC_CFG definable
             Added JFFS2 support for the SC3 board.
Signed-off-by: Heiko Schocher <hs@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Some code cleanup.

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Heiko Schocher <hs@denx.de>

Haiying Wang's modification to the reset command was broken, undo it.
Signed-off-by: Wolfgang Denk <wd@denx.de>

Also display enabled/disabled RAID 6 support for 440SP/440SPe PPC's.
Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.

Also the EBC initialising is now done via defines in the board config
file.
Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.

Also the EBC initialising is now done via defines in the board config
file.
Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.
Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Heiko Schocher <hs@denx.de>