1. 12 Mar, 2012 4 commits
  2. 06 Mar, 2012 17 commits
  3. 04 Mar, 2012 3 commits
    • Thomas Weber's avatar
    • Linus Walleij's avatar
      integrator: remove fragile delay loop from PCI code · fca94c3f
      Linus Walleij authored
      The reference implementation of the PCI initialization code almost
      everywhere contain this fragile loop of "a few usecs", and its
      use of volatile variables to delay a number of bus cycles is indeed
      Reading the manual "Integrator/AP Users Guide", page 5-15 it is
      clearly stated:
      "Wait until 230ms after the end of the reset period before
      accessing V360EPC internal registers. The V360EPC supports the
      use of a serial configuration PROM and the software must wait for
      the device to detect the absence of this PROM before accessing any
      registers. The required delay is a function of the PCI Clock, but
      at the lower frequency (25MHz) is 230ms".
      So let's simply wait 230ms per the spec.
      This solves the compilation error that looked like this:
      pci.c: In function ‘pci_init_board’:
      pci.c:286:18: warning: variable ‘j’ set but not used
      Reported-by: default avatarWolfgang Denk <wd@denx.de>
      Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
    • Linus Walleij's avatar
      pci: move pciauto_config_init() to pci.h · a1e47b66
      Linus Walleij authored
      Fixing build regressions for the Integrator I get find that a few
      boards try to work around the missing declaration of
      pciauto_config_init() by declaring it in the local scope. This
      does not make sense when the sibling functions are in <pci.h>
      so move the function to the header, ridding the build error
      in the Integrator and getting rid of the local declarations
      here and there.
      Reported-by: default avatarWolfgang Denk <wd@denx.de>
      Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
  4. 03 Mar, 2012 13 commits
  5. 29 Feb, 2012 1 commit
    • prabhakar.csengg@gmail.com's avatar
      Ethernut 5: fix build error · 2271e7c6
      prabhakar.csengg@gmail.com authored
      Fix build error for ethernut5 board due to prototype change
      for function board_mmc_getcd().
      ethernut5.c:238: error: conflicting types for 'board_mmc_getcd'
      u-boot/include/mmc.h:318: note: previous declaration of 'board_mmc_getcd'
      was here
      make[2]: *** [ethernut5.o] Error 1
      Signed-off-by: default avatarPrabhakar Lad <prabhakar.csengg@gmail.com>
      Cc: Tim Schendekehl <tim.schendekehl@egnite.de>
      Cc: Thierry Reding <thierry.reding@avionic-design.de>
      Cc: Albert ARIBAUD <albert.u.boot@aribaud.net>
      Cc: egnite GmbH <info@egnite.de>
  6. 28 Feb, 2012 2 commits