README 1.13 KB
Newer Older
1 2 3 4 5
U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

6 7
Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 dual lite and mx6 solo.
8 9 10 11 12 13 14 15 16

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard Dual Lite version:

Luka Perkov's avatar
Luka Perkov committed
17
$ make wandboard_dl_config
18 19 20 21
$ make

To build U-Boot for the Wandboard Solo version:

Luka Perkov's avatar
Luka Perkov committed
22
$ make wandboard_solo_config
23 24
$ make

25 26 27 28 29
To build U-Boot for the Wandboard Quad version:

$ make wandboard_quad_config
$ make

30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45
Flashing U-boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card;

$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync

(Note - the SD card node may vary, so adjust this as needed).

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-boot messages will appear in the serial console.