• Shengzhou Liu's avatar
    powerpc/t1024qds: Add T1024 QDS board support · aba80048
    Shengzhou Liu authored
    T1024QDS is a high-performance computing evaluation, development and
    test platform for T1024 QorIQ Power Architecture processor.
    
    T1024QDS board Overview
    -----------------------
    - T1024 SoC integrating two 64-bit e5500 cores up to 1.4GHz
    - CoreNet fabric supporting coherent and noncoherent transactions with
      prioritization and bandwidth allocation
    - 32-/64-bit DDR3L/DDR4 SDRAM memory controller with ECC and interleaving support
    - Accelerator: DPAA components consist of FMan, BMan, QMan, DCE and SEC
    - Ethernet interfaces:
      - Two 10M/100M/1G RGMII ports on-board
      - Three 1G/2.5Gbps SGMII ports
      - Four 1Gbps QSGMII ports
      - one 10Gbps XFI or 10Base-KR interface
    - SerDes: 4 lanes up to 10.3125GHz Supporting SGMII/QSGMII, XFI, PCIe, SATA and Aurora
    - PCIe: Three PCI Express controllers with five PCIe slots.
    - IFC: 128MB NOR Flash, 2GB NAND Flash, PromJet debug port and Qixis FPGA
    - Video: DIU supports video up to 1280x1024x32 bpp.
      - Chrontel CH7201 for HDMI connection.
      - TI DS90C387R for direct LCD connection.
      - Raw (not encoded) video connector for testing or other encoders.
    - QUICC Engine block
      - 32-bit RISC controller for flexible support of the communications peripherals
      - Serial DMA channel for receive and transmit on all serial channels
      - Two universal communication controllers, supporting TDM, HDLC, and UART
    - Deep Sleep power implementaion (wakeup from GPIO/Timer/Ethernet/USB)
    - eSPI: Three SPI flash devices.
    - SATA: one SATA 2.O.
    - USB: Two USB2.0 ports with internal PHY (one Type-A + one micro Type mini-AB)
    - eSDHC: Support SD, SDHC, SDXC and MMC/eMMC.
    - I2C: Four I2C controllers.
    - UART: Two UART on board.
    Signed-off-by: 's avatarShengzhou Liu <Shengzhou.Liu@freescale.com>
    [York Sun: Fix ft_board_setup() type, fix MAINTAINERS for SECURE_BOOT
    	   Fix Kconfig by adding SUPPORT_SPL]
    Reviewed-by: 's avatarYork Sun <yorksun@freescale.com>
    aba80048
T1024QDS_SPIFLASH_defconfig 147 Bytes