• Peng Fan's avatar
    arm: imx: add i.MX6SLL EVK board support · 47f73504
    Peng Fan authored
    Add i.MX6SLL EVK board support.
    1. Add imx6sll-evk device tree.
    2. Enable SDHC/I2C/UART.
    3. Enable REGULATOR/PMIC/I2C/GPIO/SDHC/PINCTRL driver.
    
    Boot Log:
    U-Boot 2016.11-00127-gc635871-dirty (Nov 24 2016 - 13:28:19 +0800)
    
    CPU:   Freescale i.MX6SLL rev1.0 at 792MHz
    CPU:   Commercial temperature grade (0C to 95C)Reset cause: POR
    Model: Freescale i.MX6SLL EVK Board
    Board: MX6SLL EVK
    DRAM:  2 GiB
    i2c bus 0 at 35258368, no gpio pinctrl state.
    PMIC: PFUZE100! DEV_ID=0x10 REV_ID=0x21
    MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
    In:    serial
    Out:   serial
    Err:   serial
    Net:   CPU Net Initialization Failed
    No ethernet found.
    Hit any key to stop autoboot:  0
    Signed-off-by: default avatarPeng Fan <peng.fan@nxp.com>
    Cc: Stefano Babic <sbabic@denx.de>
    47f73504
mx6sllevk_defconfig 829 Bytes