Commit 012681b1 authored by Heiko Schocher's avatar Heiko Schocher Committed by Tom Rini

am33xx, spl, siemens: enable debug uart output again

a6b541b0: TI ARMv7: Don't use GD before crt0.S has set it

moves the init of the debug uart at the very end of SPL code.
Enable it for the siemens board earlier, as they print
ddr settings ... all debug output before board_init_r()
is here currently useless. Maybe we must rework this
globally?
Signed-off-by: 's avatarHeiko Schocher <hs@denx.de>
parent 062f94f0
......@@ -43,6 +43,11 @@ void set_mux_conf_regs(void)
/* Initalize the board header */
enable_i2c0_pin_mux();
i2c_set_bus_num(0);
/* enable early the console */
gd->baudrate = CONFIG_BAUDRATE;
serial_init();
gd->have_console = 1;
if (read_eeprom() < 0)
puts("Could not get board ID.\n");
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment