Commit 509fc553 authored by Mike Frysinger's avatar Mike Frysinger

Blackfin: set proper LDRFLAGS for parallel booting LDRs

In order to boot an LDR out of parallel flash, the ldr utility needs a few
flags to tell it to generate the right header.
Signed-off-by: default avatarMike Frysinger <vapier@gentoo.org>
parent f85cd469
#
# Copyright (c) 2005-2008 Analog Device Inc.
#
# (C) Copyright 2001
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
......@@ -23,3 +25,7 @@
# This is not actually used for Blackfin boards so do not change it
#TEXT_BASE = do-not-use-me
# Set some default LDR flags based on boot mode.
LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))
#
# Copyright (c) 2005-2008 Analog Device Inc.
#
# (C) Copyright 2001
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
......@@ -23,3 +25,7 @@
# This is not actually used for Blackfin boards so do not change it
#TEXT_BASE = do-not-use-me
# Set some default LDR flags based on boot mode.
LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))
#
# Copyright (c) 2005-2008 Analog Device Inc.
#
# (C) Copyright 2001
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
......@@ -25,5 +27,6 @@
#TEXT_BASE = do-not-use-me
# Set some default LDR flags based on boot mode.
LDR_FLAGS-BFIN_BOOT_UART := --port g --gpio 6
LDR_FLAGS-BFIN_BOOT_PARA := --bits 16 --dma 8
LDR_FLAGS-BFIN_BOOT_UART := --port g --gpio 6
LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))
#
# Copyright (c) 2005-2008 Analog Device Inc.
#
# (C) Copyright 2001
# Wolfgang Denk, DENX Software Engineering, wd@denx.de.
#
......@@ -23,3 +25,7 @@
# This is not actually used for Blackfin boards so do not change it
#TEXT_BASE = do-not-use-me
# Set some default LDR flags based on boot mode.
LDR_FLAGS-BFIN_BOOT_PARA := --bits 16
LDR_FLAGS += $(LDR_FLAGS-$(CONFIG_BFIN_BOOT_MODE))
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment