Commit 743d7592 authored by Paul Gortmaker's avatar Paul Gortmaker Committed by Tom Rini

sbc8641d: add basic flash setup instructions to README file

...so that I don't have to go work them out from scratch again
by peering at the manual.
Signed-off-by: 's avatarPaul Gortmaker <paul.gortmaker@windriver.com>
parent 71d55116
......@@ -26,3 +26,24 @@ and settings may change with board revisions.
--------------------
PCI:
The PCI command may hang if no boards are present in either slot.
4. Reflashing U-Boot
--------------------
The board has two independent flash devices which can be used for dual
booting, or for u-boot backup and recovery. A two pin jumper on the
three pin JP10 determines which device is attached to /CS0 line.
Assuming one device has a functional u-boot, and the other device has
a recently installed non-functional image, to perform a recovery from
that non-functional image goes essentially as follows:
a) power down the board and jumper JP10 to select the functional image.
b) power on the board and let it get to u-boot prompt.
c) while on, using static precautions, move JP10 back to the failed image.
d) use "md fff00000" to confirm you are looking at the failed image
e) turn off write protect with "prot off all"
f) get new image, i.e. "tftp 200000 /somepath/u-boot.bin"
g) erase failed image: "erase FFF00000 FFF3FFFF"
h) copy in new image: "cp.b 200000 FFF00000 40000"
i) ensure new image is written: "md fff00000"
k) power cycle the board and confirm new image works.
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment