Commit 9082405d authored by York Sun's avatar York Sun Committed by Tom Rini

powerpc: T1023RDB: Remove macro CONFIG_T1023RDB

Use TARGET_T1023RDB from Kconfig instead.
Signed-off-by: default avatarYork Sun <york.sun@nxp.com>
parent 08a37fd1
......@@ -136,7 +136,7 @@ found:
popts->data_bus_width = DDR_DATA_BUS_WIDTH_32;
#endif
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
popts->wrlvl_ctl_2 = 0x07070606;
popts->half_strength_driver_enable = 1;
popts->cpo_sample = 0x43;
......
......@@ -73,7 +73,7 @@ int board_eth_init(bd_t *bis)
case 0x135:
/* set the on-board 2.5G SGMII AQR105 PHY */
fm_info_set_phy_address(FM1_DTSEC3, SGMII_AQR_PHY_ADDR);
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
/* set the on-board 1G SGMII RTL8211F PHY */
fm_info_set_phy_address(FM1_DTSEC1, SGMII_RTK_PHY_ADDR);
#endif
......@@ -92,7 +92,7 @@ int board_eth_init(bd_t *bis)
fm_info_set_mdio(i, dev);
break;
case PHY_INTERFACE_MODE_SGMII:
#if defined(CONFIG_T1023RDB)
#if defined(CONFIG_TARGET_T1023RDB)
dev = miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME);
#elif defined(CONFIG_T1024RDB)
dev = miiphy_get_dev_by_name(DEFAULT_FM_TGEC_MDIO_NAME);
......
......@@ -19,7 +19,7 @@
#include "t102xrdb.h"
#ifdef CONFIG_T1024RDB
#include "cpld.h"
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#include <i2c.h>
#include <mmc.h>
#endif
......@@ -27,7 +27,7 @@
DECLARE_GLOBAL_DATA_PTR;
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
enum {
GPIO1_SD_SEL = 0x00020000, /* GPIO1_14, 0: eMMC, 1:SD/MMC */
GPIO1_EMMC_SEL,
......@@ -54,7 +54,7 @@ int checkboard(void)
#if defined(CONFIG_T1024RDB)
printf("Board rev: 0x%02x CPLD ver: 0x%02x, ",
CPLD_READ(hw_ver), CPLD_READ(sw_ver));
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
printf("Rev%c, ", t1023rdb_ctrl(GPIO3_GET_VERSION) + 'B');
#endif
printf("boot from ");
......@@ -74,7 +74,7 @@ int checkboard(void)
reg = ((reg & CPLD_LBMAP_MASK) >> CPLD_LBMAP_SHIFT);
printf("NOR vBank%d\n", reg);
}
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#ifdef CONFIG_NAND
puts("NAND\n");
#else
......@@ -196,7 +196,7 @@ int ft_board_setup(void *blob, bd_t *bd)
fdt_fixup_board_enet(blob);
#endif
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
if (t1023rdb_ctrl(GPIO3_GET_VERSION) > 0)
fdt_enable_nor(blob);
#endif
......@@ -204,7 +204,7 @@ int ft_board_setup(void *blob, bd_t *bd)
return 0;
}
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
/* Enable NOR flash for RevC */
static void fdt_enable_nor(void *blob)
{
......
......@@ -9,7 +9,7 @@
void fdt_fixup_board_enet(void *blob);
void pci_of_setup(void *blob, bd_t *bd);
#ifdef CONFIG_T1023RDB
#ifdef CONFIG_TARGET_T1023RDB
static u32 t1023rdb_ctrl(u32 ctrl_type);
static void fdt_enable_nor(void *blob);
#endif
......
......@@ -12,7 +12,7 @@ CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="T1023RDB,RAMBOOT_PBL,SPL_FSL_PBL,NAND"
CONFIG_SYS_EXTRA_OPTIONS="RAMBOOT_PBL,SPL_FSL_PBL,NAND"
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_SPL=y
......
......@@ -12,7 +12,7 @@ CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="T1023RDB,RAMBOOT_PBL,SPL_FSL_PBL,SDCARD"
CONFIG_SYS_EXTRA_OPTIONS="RAMBOOT_PBL,SPL_FSL_PBL,SDCARD"
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_SPL=y
......
......@@ -7,7 +7,6 @@ CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="T1023RDB"
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_HUSH_PARSER=y
......
......@@ -13,7 +13,7 @@ CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="T1023RDB,RAMBOOT_PBL,SPL_FSL_PBL,SPIFLASH"
CONFIG_SYS_EXTRA_OPTIONS="RAMBOOT_PBL,SPL_FSL_PBL,SPIFLASH"
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_SPL=y
......
......@@ -5,7 +5,6 @@ CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="T1023RDB"
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_HUSH_PARSER=y
......
......@@ -62,7 +62,7 @@
#define CONFIG_SYS_LDSCRIPT "arch/powerpc/cpu/mpc85xx/u-boot-nand.lds"
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1024_nand_rcw.cfg
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1023_nand_rcw.cfg
#endif
#define CONFIG_SPL_NAND_BOOT
......@@ -81,7 +81,7 @@
#endif
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1024_spi_rcw.cfg
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1023_spi_rcw.cfg
#endif
#define CONFIG_SPL_SPI_BOOT
......@@ -100,7 +100,7 @@
#endif
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1024_sd_rcw.cfg
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_FSL_PBL_RCW board/freescale/t102xrdb/t1023_sd_rcw.cfg
#endif
#define CONFIG_SPL_MMC_BOOT
......@@ -177,7 +177,7 @@
#define CONFIG_ENV_OFFSET 0x100000 /* 1MB */
#if defined(CONFIG_T1024RDB)
#define CONFIG_ENV_SECT_SIZE 0x10000
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_ENV_SECT_SIZE 0x40000
#endif
#elif defined(CONFIG_SDCARD)
......@@ -192,7 +192,7 @@
#define CONFIG_ENV_SIZE 0x2000
#if defined(CONFIG_T1024RDB)
#define CONFIG_ENV_OFFSET (2 * CONFIG_SYS_NAND_BLOCK_SIZE)
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_ENV_OFFSET (10 * CONFIG_SYS_NAND_BLOCK_SIZE)
#endif
#elif defined(CONFIG_SRIO_PCIE_BOOT_SLAVE)
......@@ -277,7 +277,7 @@ unsigned long get_board_ddr_clk(void);
#define CONFIG_SYS_SPD_BUS_NUM 0
#define SPD_EEPROM_ADDRESS 0x51
#define CONFIG_SYS_SDRAM_SIZE 4096 /* for fixed parameter use */
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_FSL_DDR4
#define CONFIG_SYS_DDR_RAW_TIMING
#define CONFIG_SYS_SDRAM_SIZE 2048
......@@ -303,7 +303,7 @@ unsigned long get_board_ddr_clk(void);
/* NOR Flash Timing Params */
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_NOR_CSOR CSOR_NAND_TRHZ_80
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_NOR_CSOR (CSOR_NOR_ADM_SHIFT(0) | \
CSOR_NAND_TRHZ_80 | CSOR_NOR_ADM_SHFT_MODE_EN)
#endif
......@@ -378,7 +378,7 @@ unsigned long get_board_ddr_clk(void);
| CSOR_NAND_SPRZ_224 /* Spare size = 224 */ \
| CSOR_NAND_PB(64)) /*Pages Per Block = 64*/
#define CONFIG_SYS_NAND_BLOCK_SIZE (512 * 1024)
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \
| CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \
| CSOR_NAND_ECC_MODE_4 /* 4-bit ECC */ \
......@@ -733,7 +733,7 @@ unsigned long get_board_ddr_clk(void);
#if defined(CONFIG_T1024RDB)
#define CONFIG_SYS_FMAN_FW_ADDR (3 * CONFIG_SYS_NAND_BLOCK_SIZE)
#define CONFIG_SYS_QE_FW_ADDR (4 * CONFIG_SYS_NAND_BLOCK_SIZE)
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define CONFIG_SYS_FMAN_FW_ADDR (11 * CONFIG_SYS_NAND_BLOCK_SIZE)
#define CONFIG_SYS_QE_FW_ADDR (12 * CONFIG_SYS_NAND_BLOCK_SIZE)
#endif
......@@ -766,7 +766,7 @@ unsigned long get_board_ddr_clk(void);
#define RGMII_PHY2_ADDR 0x6
#define SGMII_AQR_PHY_ADDR 0x2
#define FM1_10GEC1_PHY_ADDR 0x1
#elif defined(CONFIG_T1023RDB)
#elif defined(CONFIG_TARGET_T1023RDB)
#define RGMII_PHY1_ADDR 0x1
#define SGMII_RTK_PHY_ADDR 0x3
#define SGMII_AQR_PHY_ADDR 0x2
......
......@@ -7792,7 +7792,6 @@ CONFIG_SYS_XWAY_EBU_BOOTCFG
CONFIG_SYS_ZYNQ_QSPI_WAIT
CONFIG_SYS_ZYNQ_SPI_WAIT
CONFIG_SYS_i2C_FSL
CONFIG_T1023RDB
CONFIG_T1024RDB
CONFIG_T1040QDS
CONFIG_T2080QDS
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment