Commit 92ac8acc authored by Thierry Reding's avatar Thierry Reding Committed by Tom Rini

net: More BOOTP retry timeout improvements

It's not unusual for DHCP servers to take a couple hundred milliseconds
to respond to DHCP discover messages. One possible reason for the delay
can be that the server checks (typically using an ARP request) that the
IP it's about to hand out isn't in use yet. To make matters worse, some
servers may also queue up requests and process them sequentially, which
can cause excessively long delays if clients retry too fast.

Commit f59be6e8 ("net: BOOTP retry timeout improvements") shortened
the retry timeouts significantly, but the BOOTP/DHCP implementation in
U-Boot doesn't handle that well because it will ignore incoming replies
to earlier requests. In one particular setup this increases the time it
takes to obtain a DHCP lease from 630 ms to 8313 ms.

This commit attempts to fix this in two ways. First it increases the
initial retry timeout from 10 ms to 250 ms to give DHCP servers some
more time to respond. At the same time a cache of outstanding DHCP
request IDs is kept so that the implementation will know to continue
transactions even after a retransmission of the DISCOVER message. The
maximum retry timeout is also increased from 1 second to 2 seconds. An
ID cache of size 4 will keep DHCP requests around for 8 seconds (once
the maximum retry timeout has been reached) before dropping them. This
should give servers plenty of time to respond. If it ever turns out
that this isn't enough, the size of the cache can easily be increased.

With this commit the DHCP lease on the above-mentioned setup still takes
longer (1230 ms) than originally, but that's an acceptable compromise to
improve DHCP lease acquisition time for a broader range of setups.

To make it easier to benchmark DHCP in the future, this commit also adds
the time it took to obtain a lease to the final "DHCP client bound to
address x.x.x.x" message.
Tested-by: default avatarStephen Warren <swarren@nvidia.com>
Signed-off-by: default avatarThierry Reding <treding@nvidia.com>
parent e6c88a6b
......@@ -2036,6 +2036,24 @@ CBFS (Coreboot Filesystem) support
4th and following
BOOTP requests: delay 0 ... 8 sec
CONFIG_BOOTP_ID_CACHE_SIZE
BOOTP packets are uniquely identified using a 32-bit ID. The
server will copy the ID from client requests to responses and
U-Boot will use this to determine if it is the destination of
an incoming response. Some servers will check that addresses
aren't in use before handing them out (usually using an ARP
ping) and therefore take up to a few hundred milliseconds to
respond. Network congestion may also influence the time it
takes for a response to make it back to the client. If that
time is too long, U-Boot will retransmit requests. In order
to allow earlier responses to still be accepted after these
retransmissions, U-Boot's BOOTP client keeps a small cache of
IDs. The CONFIG_BOOTP_ID_CACHE_SIZE controls the size of this
cache. The default is to keep IDs for up to four outstanding
requests. Increasing this will allow U-Boot to accept offers
from a BOOTP client in networks with unusually high latency.
- DHCP Advanced Options:
You can fine tune the DHCP functionality by defining
CONFIG_BOOTP_* symbols:
......
......@@ -47,7 +47,12 @@
#define CONFIG_DHCP_MIN_EXT_LEN 64
#endif
ulong BootpID;
#ifndef CONFIG_BOOTP_ID_CACHE_SIZE
#define CONFIG_BOOTP_ID_CACHE_SIZE 4
#endif
ulong bootp_ids[CONFIG_BOOTP_ID_CACHE_SIZE];
unsigned int bootp_num_ids;
int BootpTry;
ulong bootp_start;
ulong bootp_timeout;
......@@ -77,6 +82,30 @@ static char *dhcpmsg2str(int type)
#endif
#endif
static void bootp_add_id(ulong id)
{
if (bootp_num_ids >= ARRAY_SIZE(bootp_ids)) {
size_t size = sizeof(bootp_ids) - sizeof(id);
memmove(bootp_ids, &bootp_ids[1], size);
bootp_ids[bootp_num_ids - 1] = id;
} else {
bootp_ids[bootp_num_ids] = id;
bootp_num_ids++;
}
}
static bool bootp_match_id(ulong id)
{
unsigned int i;
for (i = 0; i < bootp_num_ids; i++)
if (bootp_ids[i] == id)
return true;
return false;
}
static int BootpCheckPkt(uchar *pkt, unsigned dest, unsigned src, unsigned len)
{
struct Bootp_t *bp = (struct Bootp_t *) pkt;
......@@ -96,7 +125,7 @@ static int BootpCheckPkt(uchar *pkt, unsigned dest, unsigned src, unsigned len)
retval = -4;
else if (bp->bp_hlen != HWL_ETHER)
retval = -5;
else if (NetReadLong((ulong *)&bp->bp_id) != BootpID)
else if (!bootp_match_id(NetReadLong((ulong *)&bp->bp_id)))
retval = -6;
debug("Filtering pkt = %d\n", retval);
......@@ -351,8 +380,8 @@ BootpTimeout(void)
#endif
} else {
bootp_timeout *= 2;
if (bootp_timeout > 1000)
bootp_timeout = 1000;
if (bootp_timeout > 2000)
bootp_timeout = 2000;
NetSetTimeout(bootp_timeout, BootpTimeout);
BootpRequest();
}
......@@ -616,9 +645,10 @@ static int BootpExtended(u8 *e)
void BootpReset(void)
{
bootp_num_ids = 0;
BootpTry = 0;
bootp_start = get_timer(0);
bootp_timeout = 10;
bootp_timeout = 250;
}
void
......@@ -631,6 +661,7 @@ BootpRequest(void)
#ifdef CONFIG_BOOTP_RANDOM_DELAY
ulong rand_ms;
#endif
ulong BootpID;
bootstage_mark_name(BOOTSTAGE_ID_BOOTP_START, "bootp_start");
#if defined(CONFIG_CMD_DHCP)
......@@ -699,7 +730,8 @@ BootpRequest(void)
| ((ulong)NetOurEther[4] << 8)
| (ulong)NetOurEther[5];
BootpID += get_timer(0);
BootpID = htonl(BootpID);
BootpID = htonl(BootpID);
bootp_add_id(BootpID);
NetCopyLong(&bp->bp_id, &BootpID);
/*
......@@ -960,8 +992,8 @@ DhcpHandler(uchar *pkt, unsigned dest, IPaddr_t sip, unsigned src,
/* Store net params from reply */
BootpCopyNetParams(bp);
dhcp_state = BOUND;
printf("DHCP client bound to address %pI4\n",
&NetOurIP);
printf("DHCP client bound to address %pI4 (%lu ms)\n",
&NetOurIP, get_timer(bootp_start));
bootstage_mark_name(BOOTSTAGE_ID_BOOTP_STOP,
"bootp_stop");
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment