Commit a6bb0084 authored by Stephen Warren's avatar Stephen Warren Committed by Tom Warren

ARM: tegra: enable PCIe controller on p2771-0000

p2771-0000 has a couple of PCIe ports; one physically x4 desktop PCI
connector (which may run at x2 electrically, depending on the board
version and configuration) and a x1 connection to the M.2 slot (which may
not be active, depending on the board version and configuration). This
change enables those.
Signed-off-by: 's avatarStephen Warren <swarren@nvidia.com>
Signed-off-by: 's avatarTom Warren <twarren@nvidia.com>
parent 45d85f08
......@@ -10,4 +10,23 @@
cd-gpios = <&gpio_main TEGRA_MAIN_GPIO(P, 6) GPIO_ACTIVE_LOW>;
power-gpios = <&gpio_main TEGRA_MAIN_GPIO(P, 5) GPIO_ACTIVE_HIGH>;
};
pcie-controller@10003000 {
status = "okay";
pci@1,0 {
status = "okay";
nvidia,num-lanes = <2>;
};
pci@2,0 {
status = "disabled";
nvidia,num-lanes = <1>;
};
pci@3,0 {
status = "okay";
nvidia,num-lanes = <1>;
};
};
};
......@@ -10,4 +10,23 @@
cd-gpios = <&gpio_main TEGRA_MAIN_GPIO(P, 5) GPIO_ACTIVE_LOW>;
power-gpios = <&gpio_main TEGRA_MAIN_GPIO(P, 6) GPIO_ACTIVE_HIGH>;
};
pcie-controller@10003000 {
status = "okay";
pci@1,0 {
status = "okay";
nvidia,num-lanes = <4>;
};
pci@2,0 {
status = "disabled";
nvidia,num-lanes = <0>;
};
pci@3,0 {
status = "disabled";
nvidia,num-lanes = <1>;
};
};
};
......@@ -31,3 +31,25 @@ int tegra_board_init(void)
return 0;
}
int tegra_pcie_board_init(void)
{
struct udevice *dev;
uchar val;
int ret;
/* Turn on MAX77620 LDO7 to 1.05V for PEX power */
debug("%s: Set LDO7 for PEX power to 1.05V\n", __func__);
ret = i2c_get_chip_for_busnum(0, MAX77620_I2C_ADDR_7BIT, 1, &dev);
if (ret) {
printf("%s: Cannot find MAX77620 I2C chip\n", __func__);
return -1;
}
/* 0xC5 for 1.05v, enabled: bit7:6 = 11 = enable, bit5:0 = voltage */
val = 0xC5;
ret = dm_i2c_write(dev, MAX77620_CNFG1_L7_REG, &val, 1);
if (ret)
printf("i2c_write 0 0x3c 0x31 failed: %d\n", ret);
return 0;
}
......@@ -26,7 +26,12 @@ CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_RTL8169=y
CONFIG_E1000=y
CONFIG_PCI_TEGRA=y
CONFIG_TEGRA186_BPMP_I2C=y
CONFIG_SYS_NS16550=y
CONFIG_USB=y
CONFIG_DM_USB=y
CONFIG_POWER_DOMAIN=y
CONFIG_TEGRA186_POWER_DOMAIN=y
......@@ -26,7 +26,12 @@ CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_RTL8169=y
CONFIG_E1000=y
CONFIG_PCI_TEGRA=y
CONFIG_TEGRA186_BPMP_I2C=y
CONFIG_SYS_NS16550=y
CONFIG_USB=y
CONFIG_DM_USB=y
CONFIG_POWER_DOMAIN=y
CONFIG_TEGRA186_POWER_DOMAIN=y
......@@ -28,6 +28,11 @@
#define CONFIG_SYS_MMC_ENV_PART 2
#define CONFIG_ENV_OFFSET (-CONFIG_ENV_SIZE)
/* PCI host support */
#define CONFIG_PCI
#define CONFIG_PCI_PNP
#define CONFIG_CMD_PCI
#include "tegra-common-post.h"
/* Crystal is 38.4MHz. clk_m runs at half that rate */
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment