Commit b5ab663a authored by Dinh Nguyen's avatar Dinh Nguyen Committed by Marek Vasut

usb: dwc2: disable erroneous overcurrent condition

For the case where an external VBUS is used, we should enable the external
VBUS comparator in the driver. This would prevent an unnecessary overcurrent
error which would then disable the host port.

The overcurrent condition was happening on the SoCFPGA Cyclone5 devkit, thus
USB was not working on the devkit. This patch fixes that problem.
Signed-off-by: default avatarDinh Nguyen <dinguyen@opensource.altera.com>
parent 8038f6d2
......@@ -263,7 +263,9 @@ static void dwc_otg_core_init(struct dwc2_core_regs *regs)
/* Program the ULPI External VBUS bit if needed */
#ifdef CONFIG_DWC2_PHY_ULPI_EXT_VBUS
usbcfg |= DWC2_GUSBCFG_ULPI_EXT_VBUS_DRV;
usbcfg |= (DWC2_GUSBCFG_ULPI_EXT_VBUS_DRV |
DWC2_GUSBCFG_ULPI_INT_VBUS_INDICATOR |
DWC2_GUSBCFG_INDICATOR_PASSTHROUGH);
#else
usbcfg &= ~DWC2_GUSBCFG_ULPI_EXT_VBUS_DRV;
#endif
......
......@@ -152,6 +152,8 @@ struct dwc2_core_regs {
#define DWC2_GUSBCFG_ULPI_INT_VBUS_INDICATOR_OFFSET 21
#define DWC2_GUSBCFG_TERM_SEL_DL_PULSE (1 << 22)
#define DWC2_GUSBCFG_TERM_SEL_DL_PULSE_OFFSET 22
#define DWC2_GUSBCFG_INDICATOR_PASSTHROUGH (1 << 24)
#define DWC2_GUSBCFG_INDICATOR_PASSTHROUGH_OFFSET 24
#define DWC2_GUSBCFG_IC_USB_CAP (1 << 26)
#define DWC2_GUSBCFG_IC_USB_CAP_OFFSET 26
#define DWC2_GUSBCFG_IC_TRAFFIC_PULL_REMOVE (1 << 27)
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment