Commit d6276ab1 authored by Nikita Kiryanov's avatar Nikita Kiryanov Committed by Stefano Babic

arm: mx6: cm-fx6: force host mode on usb controller

On some CM-FX6 modules U-Boot attempts to configure the usb0 controller in
device mode, which renders it unavailable:
	USB0:   Port not available.
and also causes usb stop to report an error
	EHCI failed to shut down host controller.

This happens mostly on MX6 Dual based modules, and is caused by the USBPHY_CTRL
register reporting USBPHY_CTRL_OTG_ID to be 1, even when it is pulled down.
Since we do not support device mode in cm-fx6 u-boot, force all controllers to
be configured as hosts.

Cc: Stefano Babic <>
Cc: Igor Grinberg <>
Signed-off-by: default avatarNikita Kiryanov <>
Acked-by: default avatarIgor Grinberg <>
parent 9627084c
......@@ -14,6 +14,7 @@
#include <miiphy.h>
#include <netdev.h>
#include <errno.h>
#include <usb.h>
#include <fdt_support.h>
#include <sata.h>
#include <splash.h>
......@@ -330,6 +331,11 @@ static int cm_fx6_setup_usb_otg(void)
return gpio_direction_output(SB_FX6_USB_OTG_PWR, 0);
int board_usb_phy_mode(int port)
int board_ehci_hcd_init(int port)
int ret;
Markdown is supported
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment