Commit 820f8a87 authored by Grygorii Strashko's avatar Grygorii Strashko Committed by Tony Lindgren
Browse files

ARM: dts: am57xx: fix networking on boards with ksz9031 phy

Since commit bcf3440c ("net: phy: micrel: add phy-mode support for the
KSZ9031 PHY") the networking is broken on boards:
 am571x-idk
 am572x-idk
 am574x-idk
 am57xx-beagle-x15

All above boards have phy-mode = "rgmii" and this is worked before because
KSZ9031 PHY started with default RGMII internal delays configuration (TX
off, RX on 1.2 ns) and MAC provided TX delay. After above commit, the
KSZ9031 PHY starts handling phy mode properly and disables RX delay, as
result networking is become broken.

Fix it by switching to phy-mode = "rgmii-rxid" to reflect previous
behavior.

Cc: Oleksij Rempel <o.rempel@pengutronix.de>
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: Philippe Schenker <philippe.schenker@toradex.com>
Fixes: bcf3440c

 ("net: phy: micrel: add phy-mode support for the KSZ9031 PHY")
Reviewed-by: default avatarPhilippe Schenker <philippe.schenker@toradex.com>
Signed-off-by: default avatarGrygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 738b150e
......@@ -190,13 +190,13 @@ &mac_sw {
&cpsw_port1 {
phy-handle = <&ethphy0_sw>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
ti,dual-emac-pvid = <1>;
};
&cpsw_port2 {
phy-handle = <&ethphy1_sw>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
ti,dual-emac-pvid = <2>;
};
......
......@@ -433,13 +433,13 @@ &mac {
&cpsw_emac0 {
phy-handle = <&phy0>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
dual_emac_res_vlan = <1>;
};
&cpsw_emac1 {
phy-handle = <&phy1>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
dual_emac_res_vlan = <2>;
};
......
......@@ -408,13 +408,13 @@ &rtc {
&cpsw_emac0 {
phy-handle = <&ethphy0>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
dual_emac_res_vlan = <1>;
};
&cpsw_emac1 {
phy-handle = <&ethphy1>;
phy-mode = "rgmii";
phy-mode = "rgmii-rxid";
dual_emac_res_vlan = <2>;
};
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment