mainboard/google/kahlee: Update grunt touchscreen in devicetree

- Add raydium controller
- Update elan controller with reset and enable GPIOs.
- Enable 'probed' so Linux will check which controller is being used.

BUG=b:78929054
TEST=Both elan and raydium touchscreen controllers work

Change-Id: I3bd9912a4b1edc7bf1075cb649afa3eab5dca458
Signed-off-by: Martin Roth <martinroth@chromium.org>
Reviewed-on: https://review.coreboot.org/25998Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-by: Paul Menzel <paulepanter@users.sourceforge.net>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>

src/mainboard/google/kahlee/variants/grunt/devicetree.cb

@@ -135,10 +135,28 @@ chip soc/amd/stoneyridge
 		end
 	end
 	device mmio 0xfedc5000 on
+		chip drivers/i2c/generic
+			register "hid" = ""RAYD0001""
+			register "desc" = ""Raydium Touchscreen""
+			register "probed" = "1"
+			register "irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPIO_11)"
+			register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_85)"
+			register "reset_delay_ms" = "20"
+			register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_76)"
+			register "enable_delay_ms" = "1"
+			register "has_power_resource" = "1"
+			device i2c 39 on end
+		end
 		chip drivers/i2c/generic
 			register "hid" = ""ELAN0001""
 			register "desc" = ""ELAN Touchscreen""
+			register "probed" = "1"
 			register "irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPIO_11)"
+			register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_85)"
+			register "reset_delay_ms" = "20"
+			register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_76)"
+			register "enable_delay_ms" = "1"
+			register "has_power_resource" = "1"
 			device i2c 10 on end
 		end
 	end