Commit cfa2771b authored by Bartlomiej Zolnierkiewicz's avatar Bartlomiej Zolnierkiewicz
Browse files

pdc202xx_old: always enable burst mode



Alan has noticed that distros always enabled burst mode
(+ datasheet confirms that it is the right thing to do).

Thus fix pdc202xx_old host driver to do it unconditionally
and remove no longer needed CONFIG_PDC202XX_BURST option.

Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Acked-by: default avatarSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent c79b60dd
......@@ -688,23 +688,6 @@ config BLK_DEV_PDC202XX_OLD
If unsure, say N.
config PDC202XX_BURST
bool "Special UDMA Feature"
depends on BLK_DEV_PDC202XX_OLD
help
This option causes the pdc202xx driver to enable UDMA modes on the
PDC202xx even when the PDC202xx BIOS has not done so.
It was originally designed for the PDC20246/Ultra33, whose BIOS will
only setup UDMA on the first two PDC20246 cards. It has also been
used successfully on a PDC20265/Ultra100, allowing use of UDMA modes
when the PDC20265 BIOS has been disabled (for faster boot up).
Please read the comments at the top of
<file:drivers/ide/pci/pdc202xx_old.c>.
If unsure, say N.
config BLK_DEV_PDC202XX_NEW
tristate "PROMISE PDC202{68|69|70|71|75|76|77} support"
select BLK_DEV_IDEDMA_PCI
......
......@@ -3,26 +3,6 @@
* Copyright (C) 2006-2007 MontaVista Software, Inc.
* Copyright (C) 2007 Bartlomiej Zolnierkiewicz
*
* Promise Ultra33 cards with BIOS v1.20 through 1.28 will need this
* compiled into the kernel if you have more than one card installed.
* Note that BIOS v1.29 is reported to fix the problem. Since this is
* safe chipset tuning, including this support is harmless
*
* Promise Ultra66 cards with BIOS v1.11 this
* compiled into the kernel if you have more than one card installed.
*
* Promise Ultra100 cards.
*
* The latest chipset code will support the following ::
* Three Ultra33 controllers and 12 drives.
* 8 are UDMA supported and 4 are limited to DMA mode 2 multi-word.
* The 8/4 ratio is a BIOS code limit by promise.
*
* UNLESS you enable "CONFIG_PDC202XX_BURST"
*
*/
/*
* Portions Copyright (C) 1999 Promise Technology, Inc.
* Author: Frank Tiernan (frankt@promise.com)
* Released under terms of General Public License
......@@ -344,7 +324,6 @@ static void __devinit init_dma_pdc202xx(ide_hwif_t *hwif, unsigned long dmabase)
(primary_mode & 1) ? "MASTER" : "PCI",
(secondary_mode & 1) ? "MASTER" : "PCI" );
#ifdef CONFIG_PDC202XX_BURST
if (!(udma_speed_flag & 1)) {
printk(KERN_INFO "%s: FORCING BURST BIT 0x%02x->0x%02x ",
hwif->cds->name, udma_speed_flag,
......@@ -352,7 +331,6 @@ static void __devinit init_dma_pdc202xx(ide_hwif_t *hwif, unsigned long dmabase)
outb(udma_speed_flag | 1, dmabase | 0x1f);
printk("%sACTIVE\n", (inb(dmabase | 0x1f) & 1) ? "" : "IN");
}
#endif /* CONFIG_PDC202XX_BURST */
ide_setup_dma(hwif, dmabase);
}
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment