... | ... | @@ -3,7 +3,7 @@ |
|
|
## Put Librem 5 in flashing mode
|
|
|
|
|
|
* To put the phone into flash mode, unplug charging cable, remove battery, hold the Vol+ button and then re-insert battery and plug in USB cable to computer.
|
|
|
* Run `lsusb | grep NXP` in Tilix/Terminal`
|
|
|
* Run `lsusb | grep NXP` in Tilix/Terminal
|
|
|
* If you see `Bus 001 Device 012: ID 1fc9:012b NXP Semiconductors i.MX 8M Dual/8M QuadLite/8M Quad Serial Downloader` then you're good. If not, try flipping the USB-C cable going into the phone and trying again.
|
|
|
|
|
|
## Setup and flash your Librem 5
|
... | ... | @@ -11,5 +11,5 @@ |
|
|
* In Tilix/Terminal, run `sudo apt install librem5-devkit-host`
|
|
|
* Then `wget https://source.puri.sm/Librem5/librem5-devkit-tools/-/raw/master/scripts/librem5-flash-image`
|
|
|
* To make it executable, run `chmod +x librem5-flash-image`
|
|
|
* FInally, run `./librem5-flash-image --board librem5r3` to flash your phone.
|
|
|
* Finally, run `./librem5-flash-image --board librem5r3` to flash your phone.
|
|
|
* |
|
|
\ No newline at end of file |