Skip to content
Snippets Groups Projects

Version 0.2.2

Merged Version 0.2.2
sebastian.krzyszkowiak/firmware-tps6598x-nonfree:uart into master
Merged Sebastian Krzyszkowiak requested to merge sebastian.krzyszkowiak/firmware-tps6598x-nonfree:uart into master
  1. Aug 09, 2024
    • Sebastian Krzyszkowiak's avatar
      Version 0.2.2 · 62f1c066
      Sebastian Krzyszkowiak authored 
      - 0x06: Bump customer use word
- 0x4a: Enable User VID (0x316d)
        Enable User Alternate Modes (0x55415254 "UART" / 0x53544F50 "STOP")
- 0x5e: Enable Config Set 0x1f on User Mode #1 entry / exit
        Swap to UFP on User Mode #1 exit
        Enable Config Set 0x1e on User Mode #2 entry
        Return to default Config Set (0x7) on User Mode #2 exit

Added "UART Debug" Config Set with address 0x1f:

- 0x52: Enable Intel VID, Thunderbolt Mode, Emarker Override
        Allow Thunderbolt Mode autoentry
        Disable Vout 3v3 and AM Minimum Power requirements

Added "Disconnect on CC" Config Set with address 0x1e:

- 0x28: Sense Disconnect on CC (in addition to VBUS) when Sink

Note that the JSON file does not include additional Config Sets.

This adds 2 custom Alternate Modes with Purism's SVID.

Once a connected device enters the first "UART" mode, TPS65982 gets
reconfigured with "UART Debug" Config Set that's identical to default
config except of Thunderbolt configuration. Leaving this mode causes
TPS65982 to send a Data Role Swap request. This allows the device to
subsequently enter Thunderbolt Alternate Mode (after role swapping cycle
to let TPS65982 actually use the new config), exposing UART2 over USB-C
SBU pins.

Entering the second mode "STOP" enables disconnection sensing based
on CC lines (which helps to prevent power backfeeding on UART lines).
Leaving this alt-mode, either explicitly or because of disconnection,
restores the default config.

A way to use these by a debug probe may look like this:

- attach as a Source
- reject incoming Data Role Swap request
- perform alt-mode discovery
- enter "UART" alt-mode
- leave "UART" alt-mode
- accept incoming Data Role Swap request
- reject "UART" alt-mode entry request
- send Data Role Swap request
- perform alt-mode discovery
- enter "STOP" alt-mode
- enter Thunderbolt alt-mode

At this point, UART2 is exposed on SBU until disconnection (either
by VBUS, CC or Hard Reset).
      Verified
      62f1c066