USB 3 errors and consistent issues
Connecting a hub to the USB 3 port in host mode results in consistent and various issues on the USB bus and regular printing of the following errors:
[ 25.362355] tcpci 0-0052: TCPC fault - I2C Interface Error
...
[ 25.412987] tcpci 0-0052: TCPC fault - All Registers Reset To Default
With the I2C Interface Error
being by far the most prevalent. Some of the issues on the bus from various different boots include:
[ 20.481986] usb 1-1: can't set config #1, error -71
[ 25.376295] usb 1-1-port3: cannot reset (err = -71)
[ 25.382750] usb 1-1-port3: cannot reset (err = -71)
[ 25.389620] usb 1-1-port3: cannot reset (err = -71)
[ 25.394730] usb 1-1: USB disconnect, device number 2
[ 25.399889] usb 1-1-port3: cannot reset (err = -71)
[ 25.405616] usb 1-1-port3: attempt power cycle
[ 25.412987] tcpci 0-0052: TCPC fault - All Registers Reset To Default
[ 325.192560] usb 1-1.1.2-port1: Cannot enable. Maybe the USB cable is bad?