The one place for your designs
To enable design management, you'll need to meet the requirements. If you need help, reach out to our support team for assistance.
i2c dev 2 not properly probing devices in u-boot
u-boot=> gpio set GPIO1_4
gpio: pin GPIO1_4 (gpio 4) value is 1
u-boot=> i2c dev 2
Setting bus to 2
u-boot=> i2c probe 0x1a
Valid chip addresses:wait_for_sr_state: Arbitration lost sr=93 cr=80 state=2020
i2c_init_transfer: failed for chip 0x1a retry=0
wait_for_sr_state: Arbitration lost sr=93 cr=80 state=2020
i2c_init_transfer: failed for chip 0x1a retry=1
wait_for_sr_state: Arbitration lost sr=93 cr=80 state=2020
i2c_init_transfer: failed for chip 0x1a retry=2
i2c_init_transfer: give up i2c_regs=0x30a40000The bus probes fine in the kernel