... | ... | @@ -4,13 +4,13 @@ |
|
|
|
|
|
* To put the phone into flash mode, unplug charging cable, remove battery, hold the Vol+ button and then re-insert battery and plug in USB cable to computer.
|
|
|
* Run `lsusb | grep NXP` in Tilix/Terminal
|
|
|
* If you see `Bus 001 Device 012: ID 1fc9:012b NXP Semiconductors i.MX 8M Dual/8M QuadLite/8M Quad Serial Downloader` then you're good. If not, try flipping the USB-C cable going into the phone and trying again.
|
|
|
* If you see `Bus 001 Device 012: ID XXXX:XXXX NXP Semiconductors i.MX 8M Dual/8M QuadLite/8M Quad Serial Downloader` then you're good. If not, try flipping the USB-C cable going into the phone and try again.
|
|
|
|
|
|
## Setup and flash your Librem 5
|
|
|
|
|
|
* In Tilix/Terminal, run `sudo apt install librem5-devkit-host`
|
|
|
* Then `wget https://source.puri.sm/Librem5/librem5-devkit-tools/-/raw/master/scripts/librem5-flash-image`
|
|
|
* Edit script based on changes shown here: https://source.puri.sm/Librem5/librem5-devkit-tools/-/merge_requests/169/diffs#f85a6f2dbb656bd9673a20b47c3f98d8a66c1403_31_31
|
|
|
* In Tilix/Terminal, run `sudo apt install librem5-devkit-host` to install the required dependencies.
|
|
|
* `cd ~/` to make sure you're in your HOME directory.
|
|
|
* Then `wget https://source.puri.sm/Librem5/librem5-devkit-tools/-/raw/master/scripts/librem5-flash-image` for the script that flashes the phone.
|
|
|
* To make it executable, run `chmod +x librem5-flash-image`
|
|
|
* Finally, run `./librem5-flash-image --board librem5r3` to flash your phone.
|
|
|
* Once it shows `Done`, pull the USB-C cable from the phone, pull and re-seat the battery. Your Librem 5 will boot up with the latest image. |
|
|
\ No newline at end of file |
|
|
* Finally, run `./librem5-flash-image --board librem5r3` to flash your phone. Use `librem5r2` for Birch & Chestnut.
|
|
|
* It'll take a few minutes. Once it shows `Done`, pull the USB-C cable from the phone, pull and re-seat the battery. Your Librem 5 will boot up with the latest image. |
|
|
\ No newline at end of file |